How and where to use guide
Traditional Victorian Clear Pine 4 Panel Internal FD30 Fire Door 686mm x 1981mm x 44mm
Typical applications and installation
Install this door in internal doorways where fire safety regulations require fire-rated doors, such as between bedrooms and hallways, or between living areas and kitchens in residential properties. The door is supplied pre-finished and ready to hang into an existing or new frame. Ensure the frame is square and level before hanging, and use three hinges for secure support of the solid timber door. The 44mm thickness provides structural integrity and acoustic benefits. After installation, the door can be decorated with paint or stain to match your interior scheme, though any finishing should not compromise the fire rating.
- Suitable for internal doorways requiring FD30 fire compartmentalisation
- Fits standard UK door frame openings at 686mm x 1981mm
- Install using three hinges for solid timber doors
- Ensure frame is plumb and square before hanging
- Solid 44mm thickness provides durability and sound insulation
Fire safety and compliance
This door meets FD30 fire safety standards, providing 30 minutes of fire resistance when properly installed and maintained. The FD30 rating is suitable for internal use in residential properties and meets Building Regulations requirements for fire compartmentalisation. To maintain the fire rating, ensure the door is hung correctly with appropriate hinges, the frame is properly fitted, and any gaps around the door are sealed appropriately. Do not drill additional holes or make modifications that could compromise the integrity of the door leaf. If the door is damaged, it should be replaced rather than repaired, as damage may affect its fire-resistant properties.
- FD30 rating provides 30 minutes fire resistance
- Meets Building Regulations for internal fire compartmentalisation
- Maintain fire rating by avoiding unauthorised modifications
- Install with appropriate fire-rated hinges and hardware
- Replace rather than repair if door is damaged
Finishing and maintenance
The clear pine timber can be finished with paint, stain, or varnish to suit your interior design. Prepare the surface by lightly sanding if needed before applying your chosen finish. Clear pine is a stable, durable timber that responds well to traditional finishes. Once finished, maintain the door by keeping it clean and dry. Wipe down regularly with a soft cloth and avoid excessive moisture exposure, which can cause timber movement. Check hinges periodically to ensure they remain tight and the door hangs evenly. The solid timber construction means the door may require minor adjustments as timber naturally acclimatises to your property's humidity levels.
- Clear pine accepts paint, stain, and varnish finishes
- Lightly sand before finishing for best results
- Wipe clean regularly with a soft, dry cloth
- Check hinges periodically for tightness
- Allow timber to acclimatise to property humidity
On-site tips and limitations
Store the door flat and indoors for at least 48 hours before installation to allow it to acclimatise to your property's temperature and humidity. This reduces the risk of warping or sticking after hanging. The Victorian 4 panel design is fixed and cannot be altered. The door is supplied as a single leaf only and does not include frame, hinges, or hardware. Ensure you have appropriate hinges, a latch, and any required fire-rated hardware before installation. The 686mm width is suitable for standard internal doorways but check your frame opening carefully before ordering. Do not attempt to plane or sand the door significantly, as this may affect its fire rating and structural integrity.
- Acclimatise door indoors for 48 hours before hanging
- Door supplied as leaf only without frame or hardware
- Verify frame opening matches 686mm width before installation
- Use fire-rated hinges and hardware to maintain FD30 rating
- Do not plane or significantly modify the door